Physical Interfaces

Get known of the physical interfaces on the EZR13 WiFi extender.

APPEARANCE

The WiFi extender has 2x WiFi antenna sockets and 1x PoE sockets.

The WiFi antenna sockets are N-female connectors on the top side. The PoE socket is on the downside.

A brief view on physical interfaces

PORTS & SWITCHES

From the left side is a DC socket, Reset button, PoE & WAN, LAN, Indicators, and USB.

Physical ports on outdoor WiFi extender

INDICATORS

There are four indicators on the EZR13 extender. From up to down, the left side is the system & Wi-Fi, and the right side is the WiFi relay & WAN. Below are the indicator descriptions.

Indicator	Status	Description
System	Green	This light indicates that the extender is receiving power. If it's lit solid green, then the router has booted successfully.
	Flash	The extender system is booting up. The system indicator flashes while resetting or flashing the firmware.
	Off	No light at all indicates that the extender is not receiving power. Check the PoE socket connected to the motherboard and check the PoE adapter. You might need to test an alternate power socket if the router doesn't power on.
Wi-Fi	Green	This light indicates that the modem is sending a Wi-Fi signal. If the light is green, you should be able to see and connect to the Wi-Fi network.
	Flash	If you are connected to the Wi-Fi hotspot, it will flash green to indicate data going to and from the extender. If the extender is connected to another Wi-Fi hotspot (Wi-Fi relay), it will also flash because it has the data flow.
	Off	If it's off, your extender no longer sends a Wi-Fi signal. You can log in to the extender admin and turn on the Wi-Fi master hotspot.
Relay & WAN	Green	These lights indicate the extender connects to another WiFi hotspot via a WiFi relay or WAN on a LAN cable.