PoE & WAN
The WiFi extender takes DC power from the PoE adapter. It also uses the PoE adapter to connect to the master internet router via a LAN cable.
Last updated
The WiFi extender takes DC power from the PoE adapter. It also uses the PoE adapter to connect to the master internet router via a LAN cable.
Last updated
PoE, Power over Ethernet, makes the router easy to install. Both power and data will travel down the same Ethernet cable. The WiFi extender accords with the IEEE802.3 af/at standards with TIA/EIA568B wiring on the LAN cable. A 48-volt standard PoE adapter and 30-feet LAN cable are included in the package.
An IP68-rated waterproof LAN cable gland is included in the package. Follow the below steps to install the LAN cable on the router through the cable gland to provide waterproof protection on the router and PoE socket.
Take apart the cable gland.
Take the LAN cable through the cap, clamp it with the rubber stopper, through the barrel screw, then plug the RJ45 connector into the RJ45 port of the PoE socket.
Screw the barrel screw on the base PoE socket.
Insert rubber stopper into barrel screw, and crew down the cap tightly.
When disconnecting the LAN cable from the router, first take off the cap and then unscrew the barrel screw.
A 48-Volt PoE adapter is included in the package. There are two RJ45 ports on the PoE adapter. Connect the PoE port to the extender via LAN cable. Then, connect the PoE adapter to the electrical outlet. It can take 110~240 Volt AC power and output 48-Volt 0.5Amps DC power to the extender.
If you receive more than one power plug, press the push button, then slide the power plug upside down and take off the plug. You can then exchange it with another power plug for the PoE adapter.
A 30-feet outdoor-grade LAN cable is included in the package. You can use a 320-feet LAN cable. Please use Cat5 or higher-grade LAN cable between the extender and PoE adapter. An outdoor-grade LAN cable is recommended if you use the extender in the outdoor environment.
There will be a distinct attenuation on the Ethernet signal when the LAN cable is more extended than 160 feet. Please use a PoE extender when sending an Ethernet signal more than 160 feet away. The PoE extender can give you an extra 320-feet distance.
To input the Internet signal to the extender, connect the LAN port on the PoE adapter to the LAN port on the Internet router.
WAN port is bound to the eth1 physical RJ45 port, which PoE also uses
Another RJ45 LAN port is bound to eth0 which is not connected to the PoE adapter
To change the extender to router mode, the LAN port needs to bind to eth1 to connect to the PoE adapter.
Log in to the extender admin. Go to Network > Interface. Click Edit on the row of LAN. Click the tab of Physical Settings, bind eth1 on the Interface field, and click the button Save & Apply.
Please remember to edit the WAN interface and bind the physical interface to eth0.
Then, we can connect the LAN port on the PoE adapter to a computer or secondary router via LAN cable. You will get the Ethernet signal from the extender. Make sure to connect to the WAN port on the secondary router. The extender has turned on DHCP by default. Ensure your router or computer turns on DHCP to obtain the IP address.
