HomeShop

Recovery

Fix the issues on the Internet and wireless networks and rescue the extender from misconfigurations.

Reboot Extender

Like a regular computer, the WiFi extender runs on a Linux-based operation system. Rebooting the router can solve some of the mysterious problems, fix the Internet connectivity issues, and improve the security level.

The Internet provider assigns a temporary IP address that can be changed during a timeout. If the extender misses the change, the Internet connection might become slow. The same can happen if too many devices are connected to the router. The routers found channels with less traffic during a reboot and raised the performance speeds.

i. Soft Reboot

After accessing the admin, go to System / Reboot, you can perform a soft reboot.

ii. Hard Reboot

To do a hard reboot, please unplug the PoE adapter, wait a few seconds, and then connect it again.

Do not disconnect from the PoE adapter while flashing firmware and resetting the extender.

Factory Reset

A factory reset will erase configurations and return the extender to its setting just after flashing.

i. Soft Factory Reset

If you want a clean slate, there is no need to flash the firmware again.

  1. After accessing the admin, go to System > Backup / Flash Firmware > Actions: Restore.

  2. Click the red button Perform resetand the Confirm button on the pop-up window.

  3. The extender will go to the System - Erasing page. The system indicator flashes while resetting.

  4. Wait 3-5 minutes until the extender completes the resetting progress and reboot.

ii. Hard Reset

The WiFi extender has a Reset button between the DC socket and the RJ45 PoE port.

  1. Power on the device and wait until the extender successfully boots up and the System indicator stops flashing.

  2. Press and keep pushing the Reset button for 5 seconds.

  3. Release the Reset button.

  4. The extender starts resetting the firmware, and the system indicator flashes.

  5. Wait 3-5 minutes until the extender completes the resetting progress and reboot.

  • Do not turn off the power or disconnect from the PoE adapter or power supply while resetting the extender.

  • Before disconnecting from the power source, ensure the extender completes the resetting progress and is rebooted.

Last updated